Use Instructions

In a clean recipient, add clean water to the powder, in the quantity shown in the packaging. Make the mixture in a continuous manner until it becomes pasty, homogeneous and without air pockets. After preparing, leave the mortar resting for 15 minutes and then mix again.

The substrate, which will receive the dry set mortar, must be clean and clear of strange materials (oils, powder, paint) that might avoid a good bonding. With the smooth side of the notched trowel, spread mortar on the prepared substrate forming a coat 3 to 4 mm thick.

Then, with the dented side of the notched trowel in an inclined position of approximately 60 degrees, spread the mortar laterally on a horizontal basis, to achieve integral lines: continuous and uniform.

The Interior Binder Votomassa is ideal for the setting of floors and walls. Apply the dry ceramic tiles on the lines of mortar. Press the tiles with the rubber mallet.

For tiles, equal to or larger than 900 cm2, or with re-entries and protuberances larger than 1 mm, one must also apply dry set mortar on the back of each piece and use the 8 x 8 x 8 mm finish trowel.

IMPORTANT

The substrate must have a minimum of 14 days curing.    For ceramic tiles equal or larger than 400 cm2, we recommend using the 8 x 8 x 8 mm finish trowel.