Use Instructions

In a clean recipient, add clean water to the powder, in the quantity shown in the packaging, and mix until a homogeneous paste without air pockets is formed, obtaining in this way a pasty and bonding mixture. After preparing, leave the mortar resting for 15 minutes and remix immediately.

For the substrate to remain completely clean, it is recommended to scrub thoroughly to withdraw all impregnated material in the substrate, and then wash with water.

Use the smooth side of the metal finish trowel to spread the Concentrated Binder mortar in panels on the prepared concrete substrate, forming thereby a minimum 3 mm thick uniform coat. With the dented side of the notched trowel in an inclined position of approximately 60 degrees withdraw the excess of material and form the lines randomly (“zigzag”) in an integral manner: uniform and continuous.